| Item type |
紀要論文 / Departmental Bulletin Paper(1) |
| 公開日 |
2015-03-26 |
| タイトル |
|
|
タイトル |
Al板の壓延條件と深絞り耳との關係について(第3報)(99.7% Alの耳と再結晶集合組織) |
| 言語 |
|
|
言語 |
jpn |
| 資源タイプ |
|
|
資源タイプ識別子 |
http://purl.org/coar/resource_type/c_6501 |
|
資源タイプ |
departmental bulletin paper |
| その他のタイトル（英） |
|
|
その他のタイトル |
On the Relation between Ears in Deep-Drawing of Al Plates and their Rolling Conditions. (Report No.3) (Ears of 99.7% Al Plate and its Preferred Orientation) |
| 著者 |
麻田, 宏
田中, 英八郎
小池, 吉藏
ASADA, Hiroshi
TANAKA, Eihachiro
KOIKE, Kichizo
|
| 著者所属 |
|
|
|
東京大學理工學研究所 |
| 著者所属 |
|
|
|
東京大學理工學研究所 |
| 著者所属 |
|
|
|
東京大學理工學研究所 |
| 著者所属（英） |
|
|
|
en |
|
|
THE INSTITUTE OF SCIENCE AND TECHNOLOGY, UNIVERSITY OF TOKYO |
| 著者所属（英） |
|
|
|
en |
|
|
THE INSTITUTE OF SCIENCE AND TECHNOLOGY, UNIVERSITY OF TOKYO |
| 著者所属（英） |
|
|
|
en |
|
|
THE INSTITUTE OF SCIENCE AND TECHNOLOGY, UNIVERSITY OF TOKYO |
| 出版者 |
|
|
出版者 |
東京大学理工学研究所 |
| 書誌情報 |
東京大學理工學研究所報告
巻 5,
号 5,
p. 159-166,
発行日 1951-11-30
|
| 抄録（英） |
|
|
内容記述タイプ |
Other |
|
内容記述 |
(1) Ears of Al plates cold-rolled increase their height linearly with the effective strain of the cold-rolling reduction. (2) After recrystallization, ears of Al plates cold-rolled about 50% are occurred by (100)[100]+(110)[110] texture. But when annealing temperature is higher (600℃) their height becmes low, because only (110)[110] texture must bring about ears. (3) Ears of Al plates cold-rolled 80% are occurred by (100)[100] texture, but the height of ears is constant during annealing temperature is 375℃～600℃, because the number of grains orientated to (100)[100] does not change. (4) 45° ears appeared in recrystallized plates cold-rolled 90% or 92% are due to (110) [112] like texture (at angle 40°～50°in Fig.6), but they diminish with the increasing of (100)[100] texture. (5) On Al plates cold-rolled 92% or more, behaviors of ears may be explained as well. (6) Annealing temperature where 45° ears change to 90° ears increases almost linearly with the effective strain of plates cold-rolled finally over 90%. (7) The smaller the grain size before final cold-rolling, the higher the 0° ears, 90° ears and the regularity of (100)[100]. (Received September 12, 1951) |
| ISSN |
|
|
収録物識別子タイプ |
ISSN |
|
収録物識別子 |
0371-6090 |
| 書誌レコードID |
|
|
収録物識別子タイプ |
NCID |
|
収録物識別子 |
AN00162611 |
| 資料番号 |
|
|
内容記述タイプ |
Other |
|
内容記述 |
資料番号: SA2410092000 |
SA2410092.pdf (1.2 MB)
