| Item type |
紀要論文 / Departmental Bulletin Paper(1) |
| 公開日 |
2015-03-26 |
| タイトル |
|
|
タイトル |
Al板の壓延條件と深絞り耳との關係について(第4報)(99.97% Al及びFe, Siの影響) |
| 言語 |
|
|
言語 |
jpn |
| 資源タイプ |
|
|
資源タイプ識別子 |
http://purl.org/coar/resource_type/c_6501 |
|
資源タイプ |
departmental bulletin paper |
| その他のタイトル（英） |
|
|
その他のタイトル |
On the Relation between Ears in Deep-Drawing of Al Plates and their Rolling Conditions. (Report No.4) (Ears of 99.97% Al Plate and Effects of Fe and Si Contents) |
| 著者 |
麻田, 宏
田中, 英八郎
小池, 吉藏
ASADA, Hiroshi
TANAKA, Eihachiro
KOIKE, Kichizo
|
| 著者所属 |
|
|
|
東京大學理工學研究所 |
| 著者所属 |
|
|
|
東京大學理工學研究所 |
| 著者所属 |
|
|
|
東京大學理工學研究所 |
| 著者所属（英） |
|
|
|
en |
|
|
THE INSTITUTE OF SCIENCE AND TECHNOLOGY, UNIVERSITY OF TOKYO |
| 著者所属（英） |
|
|
|
en |
|
|
THE INSTITUTE OF SCIENCE AND TECHNOLOGY, UNIVERSITY OF TOKYO |
| 著者所属（英） |
|
|
|
en |
|
|
THE INSTITUTE OF SCIENCE AND TECHNOLOGY, UNIVERSITY OF TOKYO |
| 出版者 |
|
|
出版者 |
東京大学理工学研究所 |
| 書誌情報 |
東京大學理工學研究所報告
巻 5,
号 6,
p. 235-240,
発行日 1951-12-30
|
| 抄録（英） |
|
|
内容記述タイプ |
Other |
|
内容記述 |
From Fig.1 and Fig.2, grains orientated in (100)[100], (331)[110] and (110)[100] can be seen conspicuously. (These textures produce the O° and 90° ears.) AS shown in Fig.3, the height of ears is constant in spite of different rolling conditions and annealing temperatures of plates (see page 237). But causes of ears must be different, because from Fig.1 and Fig.2 we can see different orientation in each plate. That is the most interesting difference compared with 99.7% Al plates. From Table 4 and Fig. 4, the smaller the grain size before the final cold-rolling, the higher the height of ears after annealing, and the regularity of (100)[100] is also as 99.7% Al plate. From Fig.5 and Fig.6 (a), the 45° ears in annealed plates occur only, in plates cold-rolled 98%, of which preferred orientation is shown in Fig.6 (b), There are (110)[112] and (100)[100] textures, but it seems (110)[112] may be active for the forming of ears. The behavior of 99.97% Al plate contained Fe 0.91% (No.4 in Table 1) and Fe 0.12%, Si 0.12% are the same as that of 99.7% Al plate. The effect of Si is less than that of Fe. (Received October 30, 1951) |
| ISSN |
|
|
収録物識別子タイプ |
ISSN |
|
収録物識別子 |
0371-6090 |
| 書誌レコードID |
|
|
収録物識別子タイプ |
NCID |
|
収録物識別子 |
AN00162611 |
| 資料番号 |
|
|
内容記述タイプ |
Other |
|
内容記述 |
資料番号: SA2410108000 |
SA2410108.pdf (543.6 kB)
