@techreport{oai:jaxa.repo.nii.ac.jp:00044222,
 author = {佐藤, 衛 and 神田, 宏 and 須谷, 記和 and 馬場, 滋夫 and 三輪, 等 and 河本, 巌 and SATO, Mamoru and KANDA, Hiroshi and SUDANI, Norikazu and BABA, Shigeo and MIWA, Hitoshi and KAWAMOTO, Iwao},
 month = {Aug},
 note = {In order to investigate the capability of conducting force measurements of three-dimensional (3-D) models in NAL′s two-dimensional (2-D) wind tunnel, force measurements on AGARD calibration Model-B (Mach numbers: 0.5-1.1, Reynolds number : 3×106and 4×106). Full and half models were tested. Four different strut lengths having a circular arc cross-section and stings were used to install the full model. For the half model, a plate was installed to remove the effects of the wind tunnel′s sidewall boundary layer, as well as adding a small gap between the model and the plate to remove the effects of the plate′s boundary layer. It was shown that force measurements of 3-D models are possible in NAL′s 2-D wind tunnel, although improvements in the struts and stings are necessary to conduct tests at Mach numbers greater than 0.85., 資料番号: NALTM0639000, レポート番号: NAL TM-639},
 title = {二次元風洞におけるAGARD-B標準模型の三分力試験},
 year = {1991}
}