| Item type |
テクニカルレポート / Technical Report(1) |
| 公開日 |
2015-03-26 |
| タイトル |
|
|
タイトル |
Experimental study of thermocapillary flow in the half-zone liquid bridge of low Prandtl number fluid |
|
言語 |
en |
| 言語 |
|
|
言語 |
eng |
| キーワード |
|
|
主題Scheme |
Other |
|
主題 |
熱電対 |
| キーワード |
|
|
主題Scheme |
Other |
|
主題 |
Prandtl数 |
| キーワード |
|
|
主題Scheme |
Other |
|
主題 |
液柱 |
| キーワード |
|
|
主題Scheme |
Other |
|
主題 |
熱毛管流 |
| キーワード |
|
|
主題Scheme |
Other |
|
主題 |
数値解析 |
| キーワード |
|
|
主題Scheme |
Other |
|
主題 |
振動流 |
| キーワード |
|
|
主題Scheme |
Other |
|
主題 |
マランゴニ対流 |
| キーワード |
|
|
主題Scheme |
Other |
|
主題 |
表面張力 |
| キーワード |
|
|
言語 |
en |
|
主題Scheme |
Other |
|
主題 |
thermocouple |
| キーワード |
|
|
言語 |
en |
|
主題Scheme |
Other |
|
主題 |
Prandtl number |
| キーワード |
|
|
言語 |
en |
|
主題Scheme |
Other |
|
主題 |
liquid bridge |
| キーワード |
|
|
言語 |
en |
|
主題Scheme |
Other |
|
主題 |
thermocapillary flow |
| キーワード |
|
|
言語 |
en |
|
主題Scheme |
Other |
|
主題 |
numerical analysis |
| キーワード |
|
|
言語 |
en |
|
主題Scheme |
Other |
|
主題 |
oscillating flow |
| キーワード |
|
|
言語 |
en |
|
主題Scheme |
Other |
|
主題 |
Marangoni convection |
| キーワード |
|
|
言語 |
en |
|
主題Scheme |
Other |
|
主題 |
surface tension |
| 資源タイプ |
|
|
資源タイプ識別子 |
http://purl.org/coar/resource_type/c_18gh |
|
資源タイプ |
technical report |
| その他のタイトル |
|
|
その他のタイトル |
低プラントル数流体のハーフゾーン液柱における熱毛管流の実験研究 |
| 著者 |
松本, 聡
林田, 均
小宮, 敦樹
夏井, 秀定
依田, 真一
Matsumoto, Satoshi
Hayashida, Hitoshi
Komiya, Atsuki
Natsui, Hidesada
Yoda, Shinichi
|
| 著者所属 |
|
|
|
宇宙開発事業団 |
| 著者所属 |
|
|
|
宇宙開発事業団 |
| 著者所属 |
|
|
|
宇宙開発事業団 |
| 著者所属 |
|
|
|
エイ・イー・エス |
| 著者所属 |
|
|
|
宇宙開発事業団 |
| 著者所属（英） |
|
|
|
en |
|
|
National Space Development Agency of Japan |
| 著者所属（英） |
|
|
|
en |
|
|
National Space Development Agency of Japan |
| 著者所属（英） |
|
|
|
en |
|
|
National Space Development Agency of Japan |
| 著者所属（英） |
|
|
|
en |
|
|
Advanced Engineering Services Co. Ltd. |
| 著者所属（英） |
|
|
|
en |
|
|
National Space Development Agency of Japan |
| 出版者 |
|
|
出版者 |
宇宙開発事業団 |
| 出版者（英） |
|
|
出版者 |
National Space Development Agency of Japan (NASDA) |
| 書誌情報 |
宇宙開発事業団技術報告: マランゴニ対流現象モデル研究:アニュアルレポート2002
en : NASDA Technical Memorandum: Marangoni Convection Modeling Research: Annual Report April 1, 2002-March 31, 2003
p. 157-184,
発行日 2003-08-29
|
| 抄録（英） |
|
|
内容記述タイプ |
Other |
|
内容記述 |
The experimental study on thermocapillary convection of low Prandtl number fluid was carried out to understand transition behavior to oscillatory flow. The half-zone liquid bridge of molten tin was formed between hot and cold disks in high vacuum chamber (10(exp -5) Pa). The three radiation thermometers were used to measure the free surface temperature at a different azimuthal location at the same time. In addition, the temperature distribution at interface between liquid bridge and cold disk was measured by using very fine thermocouples to detect the transition point and to make clear the oscillation mode more precisely. It can be detected that the steady thermocapillary convection changes to oscillatory under certain condition. The observed phenomena of transition processes after the oscillatory onset were revealed by comparing to numerical result done by Imaishi et al. The effect of aspect ratio (L/r) on critical Marangoni number was investigated. The critical Marangoni number decreases with increasing aspect number. This behavior agrees with numerical simulation done by Imaishi et al. qualitatively except for region of smaller aspect ratio. The surface tension and its temperature coefficient were measured in the experimental chamber. A molten tin droplet was formed on an alpha-Al2O3 substrate in the evacuated experimental chamber. These analog photo images were transfer to digital images and the surface tension was calculated from the outlines of digital image, which was the sessile drop method. The value of surface tension and its temperature coefficient were 520 to 550 [mN/m] and 0.097 [mN/m/K]. The Fe-Ni/SB tracer particle has been developed for the visualization of the inner flow pattern of the Marangoni convection. Considering the traceability of the particle, high wettability and low reactivity with surrounding fluid, and high sphericity are required. Therefore, the multi-layer structure, which comprises Fe and Ni layers, was adopted. The plating techniques of both Fe and Ni layers were developed and the heat treatment technique to make the high sphericity particles was also developed. The test particle has already been manufactured and its reflectance of ultrasonic beam has been evaluated. |
| ISSN |
|
|
収録物識別子タイプ |
ISSN |
|
収録物識別子 |
1345-7888 |
| 書誌レコードID |
|
|
収録物識別子タイプ |
NCID |
|
収録物識別子 |
AN00364784 |
| 資料番号 |
|
|
内容記述タイプ |
Other |
|
内容記述 |
資料番号: AA0046980006 |
| レポート番号 |
|
|
内容記述タイプ |
Other |
|
内容記述 |
レポート番号: NASDA-TMR-030004E |
46980006.pdf (4.6 MB)
