| Item type |
テクニカルレポート / Technical Report(1) |
| 公開日 |
2015-03-26 |
| タイトル |
|
|
タイトル |
ロケット用小型高速高揚程液体酸素ポンプの実験的研究 |
| 言語 |
|
|
言語 |
jpn |
| 資源タイプ |
|
|
資源タイプ識別子 |
http://purl.org/coar/resource_type/c_18gh |
|
資源タイプ |
technical report |
| 著者 |
上條, 謙二郎
鈴木, 昭夫
志村, 隆
橋本, 亮平
渡辺, 光男
渡辺, 義明
岩渕, 俊雄
毛利, 義広
KAMIJO, Kenjiro
SUZUKI, Akio
SHIMURA, Takashi
HASHIMOTO, Ryohei
WATANABE, Mitsuo
WATANABE, Yoshiaki
IWABUCHI, TOSHIO
MOURI, YOSHIHIRO
|
| 著者所属 |
|
|
|
角田支所 |
| 著者所属 |
|
|
|
角田支所 |
| 著者所属 |
|
|
|
角田支所 |
| 著者所属 |
|
|
|
角田支所 |
| 著者所属 |
|
|
|
角田支所 |
| 著者所属 |
|
|
|
角田支所 |
| 著者所属 |
|
|
|
角田支所 |
| 著者所属 |
|
|
|
東北大学工学部 |
| 著者所属 |
|
|
|
元・角田支所 |
| 著者所属（英） |
|
|
|
en |
|
|
Kakuda Branch Office, National Aerospace Laboratory(NAL) |
| 著者所属（英） |
|
|
|
en |
|
|
Kakuda Branch Office, National Aerospace Laboratory(NAL) |
| 著者所属（英） |
|
|
|
en |
|
|
Kakuda Branch Office, National Aerospace Laboratory(NAL) |
| 著者所属（英） |
|
|
|
en |
|
|
Kakuda Branch Office, National Aerospace Laboratory(NAL) |
| 著者所属（英） |
|
|
|
en |
|
|
Kakuda Branch Office, National Aerospace Laboratory(NAL) |
| 著者所属（英） |
|
|
|
en |
|
|
Kakuda Branch Office, National Aerospace Laboratory(NAL) |
| 著者所属（英） |
|
|
|
en |
|
|
Kakuda Branch Office, National Aerospace Laboratory(NAL) |
| 著者所属（英） |
|
|
|
en |
|
|
Tohoku University |
| 著者所属（英） |
|
|
|
en |
|
|
Former Kakuda Branch Office, National Aerospace Laboratory(NAL) |
| 出版者 |
|
|
出版者 |
航空宇宙技術研究所 |
| 出版者（英） |
|
|
出版者 |
National Aerospace Laboratory(NAL) |
| 書誌情報 |
航空宇宙技術研究所報告
en : Technical Report of National Aerospace Laboratory TR-415
巻 415,
p. 41,
発行日 1975-08
|
| 抄録（英） |
|
|
内容記述タイプ |
Other |
|
内容記述 |
Recently, high performance liquid rocket engines tend to require oxygen pumps of higher speed and higher head. In order to develop oxygen pumps to meet these requirements, various problems must be overcome. In this study, a small, high speed, high head centrifugal liquid oxygen pump(N=20,000 rpm, Hp=1,051m, Q=18 l/s, Ns=118) was designed and experiments were conducted in many aspects using water and liquid nitrogen as test fluids. A preliminary experiment with cambered inducers was conducted in a water cavitation tunnel and it was clarified that the attack angle of inducers decisively determines the cavitation performance. The inducer of the pump investigated was designed according to the results of this preliminary experiment and showed good suction performance. The validity of the other design procedures discussed in this report was also clarified because of the good general performance of the pump. Liquid nitrogen and water tests showed a little difference in general performance. In particular, liquid nitrogen brought about a little better pump efficiency but lower volumetric efficiency than water. The former may be attributed to the decrease of disk friction and hydraulic losses and the latter to the increase of leakage loss, due to the extremely lower viscosity of liquid nitrogen. In the test using liquid nitrogen, the amount of required NPSH(net positive suction head) decrease due to the thermodynamic effects of cavitation was measured and two-phase operation was experienced. Some unsteady characteristics of the pump were investigated by measuring pressure oscillations at the pump inlet and outlet. The pressure oscillations of low and medium frequencies occurred in the pump circuit and these oscillations became more serious at lower flow rate. In this experiment, also, the radial and axial thrusts were examined and confirmation of ball bearings, mechanical seals and plastic wearings lubricated with cryogenic fluids was made. |
| ISSN |
|
|
収録物識別子タイプ |
ISSN |
|
収録物識別子 |
0389-4010 |
| 資料番号 |
|
|
内容記述タイプ |
Other |
|
内容記述 |
資料番号: NALTR0415000 |
| レポート番号 |
|
|
内容記述タイプ |
Other |
|
内容記述 |
レポート番号: NAL TR-415 |
naltr00415.pdf (10.5 MB)
